Line Sizing using PRO/II
1. Place a Pipe unit-op on the flowsheet and attach it with inlet and outlet stream.
2. Select the units of measure, components and thermodynamics as required.
3. Input the stream data.
4. Double click on the Pipe unit-op to open its Data Entry Window and select the Line Sizing – Forward Calculation radio button.
5. Click on Line/Fitting Data and enter the line or fitting data
Click OK.
6. Click on Line Sizing data and enter the required information
The primary sizing criterion is based on pressure so enter either a maximum pressure drop or minimum outlet pressure. User can also change the Pipe Diameters that are used in sizing search and the maximum Average Fluid Velocity.
7. Run the simulation and view results. There are many ways of viewing the results the below is a snapshot of results in html format.
0 comments:
Post a Comment